ALPHA NF3000 Water-Soluble Flux
Harmonization Code : 2905.12.20 | Isopropyl alcohol
Main features
- Water-soluble formulation
- Organic activating system
- Wide thermal window
Product Description
Alpha NF3000 is a water-soluble liquid soldering flux designed for the wave-soldering of printed circuit boards (PCBs). It uses an organic activating system that has a neutral pH at room temperature and becomes fully activated only at the elevated temperatures required during the soldering process. NF3000 is specifically developed to operate effectively across a wide thermal window while emitting little smoke or odor, contributing to a cleaner, safer work environment.
Product Key Features
- Water-soluble formula
- Organic activating system
- Wide thermal window
- Low smoke and odor emissions
Applications
- Wave soldering of printed circuit boards (PCBs)
AP-NF3000
Unlike other products we offer, the products listed on this page cannot currently be ordered directly from the website.
Shipping in 6 weeksPackaging
TDS, SDS & Technical Documents
- 127997_MAES NEUTRAL FLUX 3000 SDS GHS UN_English
- NF3000 TDS
Technical Specifications
General Properties
Thermal Properties
Additional Information
Flux Application
Alpha NF3000 is designed principally for application by the foam head method in wave soldering. Flux applicators and reservoirs should be plastic or titanium only. Flux coated surfaces should be preheated to provide optimum wicking and solder joint formation. A typical assembly would be preheated to between 85°C and 95°C on the topside prior to entering the wave.
The foam applicators should be supplied with compressed air which is filtered to be free of contaminant oil and water. The flux level should be maintained sufficiently above the aerator stone to produce adequate foam height. Air pressure should be adjusted to produce optimum height with foam consisting of small uniform bubbles.
During use, the specific gravity of the flux should be checked periodically with a hydrometer. Evaporated solvent should be replenished with the addition of flux thinner. For consistent soldering performance the flux should be replaced periodically. During this changeout the aerator stone should be thoroughly cleaned with flux thinner.
After soldering NF3000 residues must be removed. Removal can be accomplished by multi-zone conveyorised in-line spray systems, automated batch spray systems or multi-zone batch tank cleaning. 
