ABchimie DVA BA Non-Toxic Acrylic Thinner
Harmonization Code : 3814001000 |
Main features
- Non‑toxic solvent blend
- For AVR80 BA acrylic coating
- Easy to mix
Product Description
ABchimie DVA BA is a non‑toxic solvent blend specifically formulated for use with acrylic‑based conformal coatings. It is especially recommended for AVR80 BA, ensuring optimal coating flow, film formation, and application consistency.
Designed primarily as a dilution solvent, DVA BA adjusts the viscosity of acrylic coatings for dip coating, spray application, and selective coating processes, enabling smooth deposition and controlled coating thickness.
Product Key Features
- Non‑toxic solvent blend compatible with all acrylic conformal coatings
- Ideal dilution solvent for AVR80 BA acrylic coating
- Optimizes viscosity for dip, spray, and selective coating methods
- Easy to mix with acrylic coatings
Applications
- Dilution of acrylic conformal coatings
ABC-DVABA
Unlike other products we offer, the products listed on this page cannot currently be ordered directly from the website.
Shipping in 8 weeksPackaging
TDS, SDS & Technical Documents
- DVA BA TDS
- DVA BA SDS
Technical Specifications
No specifications available.
Additional Information
Instructions for Use
Spray Coating
When solvent based coatings are sprayed, the higher pressure at the nozzle forces the solvent within the coating to evaporate. Therefore, to avoid cob-webbing ( i.e. the coating drying immediately as it leaves the spray gun), extra solvent must be added. DVA BA should be used at levels of between 3:1 and 1:1 (Coating:Thinners) depending upon the application. To avoid microbubbles in the coating, stand 2 minutes before attempting to spray.
Dip Coating
DVA BA may be used to maintain the viscosity of acrylic conformal coatings in open tanks used in dip coating processes. Over time the solvent within the coatings evaporates, increasing the viscosity of the coating, and giving a thicker coating. This solvent loss must be replaced to maintain the correct viscosity to give an economical coating thickness.
In most systems it is sufficient to measure the viscosity of the coating once per week. DVA BA is a flammable solvent and should be used in a well ventilated area and all sources of ignition must be avoided.
The solvent DVA BA is compliance with REACH and RoHS regulations.
Recently viewed products
LINQCELL GFP3000 | Graphite Felt
- 3 mm - 3000 µm - 118 mil
- High chemical resistance, electrical conductivity, and open porosity
- Electrode materials for high-temperature batteries
LOCTITE ABLESTIK NCA 2280
- Non-conductive
- Fast cure at low temperature
- High thixotropic index
ABchimie DVP Permanent Coating Stripper
- Designed for controlled application
- Strong solvency
- Easy to apply and remove
LINQBOND SMA3602 | SMT Chipbonder
- solvent-free
- low stress
- low water absorption
